This mode is sometimes accessed by pressing a button directly on the Z-Wave controller. If your alarm system has a Z-Wave controller, then it will have some mode for excluding Z-Wave devices. Some panels may already have a Z-Wave controller installed, while others will need to have one added separately.Ĭomplete the following steps to exclude a Kwikset Z-Wave Lock and then pair it with your system:ġ. ![]() Keep in mind that a Z-Wave controller is needed to use a Kwikset Lock with an alarm system. By clearing the network first, you can be sure that the lock will successfully pair with your Z-Wave network when you go to do so. Many Z-Wave devices are paired with networks for factory testing purposes. Keep in mind that some Kwikset locks might not have this button.Įxcluding a Z-Wave device is always an important step before attempting to include it. It is recommended that you check the lock's manual for the button's exact location. It should not be confused with the lock's "B" button or "Program" button. This is usually a smaller button the is found under the lock's cover. ![]() The typical Z-Wave lock from Kwikset will have button labeled "A" that is used for both including and excluding the device from Z-Wave networks. ![]() You will then be able to successfully pair the lock with a new network. Doing this will clear the lock from the network. You can exclude your Kwikset Z-Wave Lock by activating the Z-Wave exclusion mode on your system and then pressing the button marked "A" found underneath the lock's cover.
0 Comments
Leave a Reply. |